Monolithic Flight and Landing Structures

These settings are available if you chose a Monolithic Structure type for the Flight and/or Landing.

See Choose Structure Type.

Monolithic.png 

Monolithic Flight Structure: Choose Shape

Use the four buttons to choose a shape for the bottom of a Monolithic flight. From left:

•Flat

•Stepped

•Variable Thickness (at each end)

•Filled

Below, enter values for the thickness/offset variables as applicable. Note the feedback in the Preview window.

MonolithicShape.png 

MonoStructures3D.png 

Monolithic Flight Shapes

Monolithic Support Component Settings

Use this panel to set attributes, including Building Material, for the Monolithic Flight/Monolithic Landing.

Check Uniform Flight and Landing Attributes to apply the same attributes to both Monolithic structures (Flight and Landing).

Note: The “Uniform attributes” checkbox applies only to Structure attributes, not its thickness.

MonoSupportSettings.png 

MonoLanding.png 

Draining on Flight/Draining on Landing

This panel is available for Monolithic structures only.

Check Draining to place a Draining on the left and/or right side of the Stair structure (available for both Flight and Landing).

DrainingOnFlight.png 

Check Uniform Draining Settings on Flight and Landing to apply settings to both Stair structures.

For Draining on Flight:

•Choose Draining Type (Flat or Stepped) for both Flight and Connections. This setting will be used for the Draining on Landing, if any.

Set Draining width/depth values as applicable, and an optional offset.

If needed, apply a Surface override to the Draining.

Draining3D.png 

Monolithic Stair with Draining on Both Sides