Convert Dimensions Dialog Box (Add-on)

Use Document > Annotation > Secondary Dimensions > Convert Dimensions to open this dialog box.

For general information, see Secondary Dimensions (Add-on).

Convert Dimensions

Convert to: Choose the desired dimension unit from the list.

Depending on the chosen unit, additional display options for the dimension unit appear below. Choose the desired display option.

Decimals: Enter the number of decimal places to include in each dimension.

Hide Zero Wholes: Check this box to suppress whole zero values:

Example:

•0.25 meters is displayed as 25

•25 meters is displayed as 25.00

Hide Zero Decimals: Check this box to hide any zeros at the end of the decimal dimension, regardless of the number of decimal places you set in the Decimals pop-up above.

You cannot use the Hide Zero Decimals options concurrently with Hide Zero Wholes.

Display of Zero Feet & Inches: This section has four pairs of radio buttons. For each pair, choose the option you prefer for displaying dimensions that measure either zero feet or zero inches.