Component Listing Parameters in the Interactive Schedule
The table below lists the properties that are available to list components in the Interactive Schedule.
Note: Component area properties cannot be calculated for Morphs or basic non-veneer columns.
Use these parameters in the Component lists of the Interactive Element Schedule.
|
COMPONENT PROPERTY |
DESCRIPTION |
AVAILABLE FOR ELEMENTS |
|
Component Cross Section Area |
Area of the Component cross-section |
|
|
Component Fill Outline Pen |
Pen number
|
|
|
Component Thickness |
As defined in the component |
|
|
Component Type |
Core, Finish, or Other |
|
|
Component Volume (Net) |
Volume of the component. All openings and holes are subtracted. |
|
|
Component Volume (Gross) |
Openings and holes are ignored. |
|
|
Component Volume (Conditional) |
Openings and holes are ignored in components that meet the conditions at Options > Project Preferences > Calculation Rules (“Ignore component holes...”) |
PlaneRoof / PolyRoof Shell Slab Beam Beam Segment Wall |
|
Embodied Carbon |
|
|
|
Embodied Energy |
|
|
|
Mass |
Calculated based on component's volume and the Building Material's Density value |
|
|
Projected Component Areas: |
Area is based on the projection of the virtual plane that runs through the center of the component. |
|
|
•Projected Component Area (Net) |
Openings and holes are subtracted. |
|
|
•Projected Component Area (Gross) |
Openings and holes are ignored. |
Roof Shell Slab Wall Beam Column |
|
•Projected Component Area (Conditional) |
Openings and holes are ignored in components that meet the conditions at Options > Project Preferences > Calculation Rules ("Ignore component holes...") |
Roof Shell Slab Wall |
|
Rectangular Component Height |
Height of rectangular component in 2D |
|
|
Rectangular Component Width |
Width of rectangular component in 2D |
|