Graphical Editing of MEP Elements

For any selected MEP element, use the Pet Palette commands to edit it graphically.

MEP-specific editing commands are available in the Floor Plan and 3D window.

When you edit an MEP element, certain parameters of connected (though unselected) MEP elements may change as a result.

Following the edit, every modified element becomes selected.

Specific Commands for MEP Elements

Select the MEP element(s) to be edited.

Click on an edge or node to access pet palette commands.

PetPaletteRegular.png 

Move Connection

Available for the connection node of a selected straight element connected to another straight element.

MoveConnection.png 

Use the cursor to drag the connection node, or enter values in the Tracker; this modifies the length of the segment.

Insert Node

Available for every straight MEP element, by clicking on its edge. This command will affect not just the selected MEP element, but also all straight connected elements up to the next connected junction, or to the last straight element. New bends are inserted as needed.

InsertNode.png 

Offset Edge

Affects all straight elements connected to the clicked element, including any inline, transition and junction elements.

OffsetEdge.png 

Elevate Edge (Floor Plan)

Enter the value by which you wish to elevate the selection.

ElevateEdge2D.png 

Since this is a vertical edit, you will have no feedback in the Floor Plan on the result, unless a previously connected straight segment is now disconnected: the hotspots will change.

Elevate Edge (3D Window)

Use the Tracker’s Elevation control to enter the desired value.

ElevateEdge.png 

Stretch

Available at the end of an unconnected straight segment or Flexible Duct.

StretchMEP.png 

Move Node (Flexible Duct)

Click on the Flexible Duct’s internal node.

Insert Node

Click on the Flexible Duct’s edge.

FlexEdit2.PNG  FlexEdit3.PNG

Move Node (Duct Bend)

Available from the corner point of a connected Duct Bend.

MoveNodeMEP.png 

Affects the selected Bend plus all straight elements connected to it, including any inline, transition and junction elements. The selected Bend angle will change, and new Bends are inserted as necessary.

Elevate Node

Available from the corner point of a connected Bend having a circular cross-section, in 3D window only.

Also available from the endpoint of a free-standing element having a circular cross-section.

Use this command to change the overall Slope Angle of placed, connected MEP elements.

ElevateNode.png 

Move Inline

Move an in-line element along its straight axis.

MoveInline.png 

Move Terminal (Floor Plan)

For Terminal-type MEP element in Floor Plan. The Terminal plus all connected straight segments move together.

Elevate Terminal (3D Window)

For a Terminal-type MEP element in the 3D window. Elevate or lower the Terminal element plus all of its connected straight segments simultaneously.

MoveTerminal.png