Selecting and Modifying Beam Holes

Modify Single Hole

1.Do one of the following:

With Arrow tool active, click in the center of the hole.

With any other tool active, Shift-click in the center of the hole.

Now the hole is selected.

Select1BeamHole.png   Select1BeamHoleDone.png

2.Open Beam Selection Settings - Hole Panel to modify the selected hole’s shape and size (or use the controls in the Info Box).

Select1BeamHoleSettings.png 

Shape: Rectangular or circular

Contours on Plan: Choose floor plan symbol: show outline, or show axis only

Size: Enter the horizontal and vertical dimensions of the Hole. For a circular hole, you will enter a diameter.

Position: Distance of the center of the Hole from the top surface of the Beam.

Modify all Holes

1.Select the Beam. All of the Beam holes are selected, too.

2.Open Beam Selection Settings - Hole Panel to modify all Beam holes simultaneously (or use the controls in the Info Box).

EditAllBeamHoles.png 

Move Beam Hole Graphically

Move a hole laterally along the Beam (Floor Plan or 3D)

Move a hole up and down along the Z axis (3D)

MoveBeam.png 

Holes in Curved Beams

Suppose you have placed holes into a straight beam (at the given distances from either end of the beam), and then you curve the beam (as in the picture below).

ArcBeamHole1.png 

The Beam Openings’ Position dialog box allows you to choose how to handle the holes’ new position in the curved beam:

BeamsHolesPosition.png 

Keep distance: The holes’ measured distances from the nearest beam end (as measured along the center beam arc) remain unchanged.

ArcBeamHole2.png 

Keep proportion: The holes remain at the same proportional distance from the beam ends as before.

BeamsHolesPositionProp.png