Component Listing Parameters in the Interactive Schedule

The table below lists the properties that are available to list components in the Interactive Schedule.

Note: Component area properties cannot be calculated for Morphs or basic non-veneer columns.

Use these parameters in the Component lists of the Interactive Element Schedule.

COMPONENT PROPERTY	DESCRIPTION	AVAILABLE FOR ELEMENTS
Component Cross Section Area	Area of the Component cross-section
Component Fill Outline Pen	Pen number
Component Thickness	As defined in the component
Component Type	Core, Finish, or Other
Component Volume (Net)	Volume of the component. All openings and holes are subtracted.
Component Volume (Gross)	Openings and holes are ignored.
Component Volume (Conditional)	Openings and holes are ignored in components that meet the conditions at Options > Project Preferences > Calculation Rules (“Ignore component holes...”)	PlaneRoof / PolyRoof Shell Slab Beam Beam Segment Wall
Embodied Carbon
Embodied Energy
Mass	Calculated based on component's volume and the Building Material's Density value
Projected Component Areas:	Area is based on the projection of the virtual plane that runs through the center of the component.
Projected Component Area (Net)	Openings and holes are subtracted.
Projected Component Area (Gross)	Openings and holes are ignored.	Roof Shell Slab Wall Beam Column
Projected Component Area (Conditional)	Openings and holes are ignored in components that meet the conditions at Options > Project Preferences > Calculation Rules ("Ignore component holes...")	Roof Shell Slab Wall
Rectangular Component Height	Height of rectangular component in 2D
Rectangular Component Width	Width of rectangular component in 2D