Adjuster Types and Options

The following table summarizes the available adjuster types and methods. If all the conditions for adjustment are met, the adjustment takes place: The Member in red is adjusted in relation to the black Member; the Member in black remains unadjusted.

Adjustment Method	Member Types	Stretch	Cutback	Stretch & Cutback	Offset	Snap
One to the other	1D > 1D	+	+	+	+	+
1D > 2D	+	+	+	+
2D > 1D	+	+	+	+
2D > 2D	+	+	+	+
To each other	1D <> 1D	+	+	+
2D <> 1D	+	+	+
2D <> 2D	+	+	+

Depending on the specific adjuster, you can set additional options and tolerances. These are also explained below.

Topics in this section:

Adjust Connected Ends

Offset 1D to 1D

Offset 1D to 2D

Offset 2D Member

Offset Options In Case of Multiple Targets

Snap (1D to 1D)